Tuesday, October 4, 2011

I'm an Idiot!

I got my old Linux tablet working again and connected to the Reprap.  Guess what I discovered?  The damn thing can't connect.  This indicated that the problem had nothing to do with my Windows workstation at all and was probably hardware related.  I pulled out the 6 conductor cable between the main board and the USB/TTY adapter and, sure enough, one of the leads was dead between the two connectors.  I made up a new cable and "voila" both Pronterface and Repsnapper can now connect with no problems.

I have the X and Y axis moving fine but my Z axis won't move anymore.  Probably more of my sloppy wiring.  The hot end is heating up but I don't seem to be getting any temp readings back from the thermistor.  Again, probably a hardware problem.

I tried to sending a command to the extruder but the motor didn't do anything.  I only thought afterward that the software may prevent it from running until the hot end reaches operating temperature to prevent damage from trying to push un-melted filament through the tip.  I will check the code for this.

So it looks like I am finally able to proceed with final debugging and getting Mendel working.  There's a lesson to be learned here - don't assume anything.  Just because things were working on the Linux tablet didn't automatically rule out hardware problems being the culprit.  It was really my tunnel vision on the ports that kept me from examining other possible issues earlier.

Oh well, Onward to Victory!!

Tuesday, September 27, 2011

A Possible Solution

I have been looking through the FDTI site and I may have identified my problem.  There are two types of drivers for the chip on the Techzone board - VCP drivers and D2XX drivers.  The VCP drivers set up a virtual COM port and those are the ones that I installed.  The D2XX drivers allow the software to access the USB connection directly using a DLL.

It seems possible that I should have  been using the D2XX drivers instead of the VCP ones that I installed on my workstation.  It is certainly worth a try anyway.  I will install the other set of drivers tonight and see what happens.

The Continuing Story....

I now have Repsnapper installed and working.  Unfortunately it has made no difference in my ability to connect to the Mendel.  Although Pronterface was telling me that the port was unavailable, Repsnapper tells me that it is timing out while trying to connect but has no further information.  This happens whether I attempt to connect using the original COM! port on the machine or the virtual COM3 port created by the USB/TTY interface

I am wondering if the whole problem lies with the drivers that I installed for the FTDI USB/TTY chip that is used on the Techzone board.  I am going to see if there are older versions available.

This worked so easily under Linux.  It is very frustrating to be this close to a working machine and be stopped once again.

Thursday, September 22, 2011

Connect Problem

I have tried several times to get Pronterface to talk to the Mendel but I get a message stating that it "cannot open port COM3, access is denied".  I believe that this is due to a problem in the pronterface code.  The Reprap Host Software on my Linux machine had no problem connecting.  I think that it is something to do with the communications between the PC and the USB/TTY adapter that leads Pronterface to believe that the COM port has already been opened by another application.  I have not been able to find any resolution for this in the various forums.

I am going to install Repsnapper tonight and see if it is able to connect.  Good thing that there are a number of options out there for host software.